+ Reply to Thread
Results 1 to 2 of 2

Thread: Top Front Right screw not catching

  1. #1
    Junior Member
    Join Date
    Oct 2019
    Location
    Dallas TX
    Posts
    25

    Top Front Right screw not catching

    When I go through the erect cycle and the top drops down into the screw holes, the right front screw is about 1/4" too high. the screws are aligned, and they drop into the holes neatly, but the right front doesn't go in quite enough. So, when the locking mechanisms engage the screws, the right doesn't engage initially. It engages once the left has pulled the front of the top down some. So there's an imbalance on the leading edge of the top.


    I can pull down slightly by hand the right front and it will catch properly and the top fits correctly at closure.



    I can't seem to find exactly what adjustment (presumably in the trunk mechanisms) would help 'lower' the front right ( or raise the right rear) to get the top balanced. I've tried multiple adjustments on the roof lift jacks, but that seems to mostly move the roof left or right. It doesn't need to go 'forward', just tip down a little on the right front.


    Any recommendations? thanks

  2. #2
    Member
    Join Date
    Oct 2022
    Location
    Ontario Canada
    Posts
    44
    I don't understand why you didn't get an answer to your question. The procedure to fix the problem is in volume #2 of the videos. It requires and adjustment of the control arms.

+ Reply to Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts