Hi, I see there are several questions already posted about freeze/core plugs on the big block (332cid) FE motors. I couldn't find the specific info I needed so I'm starting another thread...sorry.

I have a leaking freeze plug on my '59 Skyliner. Unfortunately, from what I can see, it is about halfway covered up by the driver's side motor-mount. I don't mind putting a rubber one in until sometime that I can replace them all with the correct metal ones. I just don't see anyway to do this job without removing the left side motor-mount.

If anyone has some advice about this problem, I sure would appreciate it. Also, the service manual says to jack up the engine to remove the 'isolation blocks'. Where can I safely jack the engine from below without damaging anything?

Thanks for any help/advice.