Quote Originally Posted by Robert M View Post
As a result, it will not lift the top and start to move it back because, I believe the geometry is off because of it not going far enough forward before it starts to retract.
I don't know anything about the roof moving forward before it starts to retract.

The way I understand it (during the retract cycle), once the package tray has extended, current goes to the lock/unlock motors that drive the 4 lock screws. Their rotation lifts the top off of the front header and rear quarter sections. Once all 4 switches (2 header and 2 quarter) have been activated by the raising of the unlock screws, the roof motor takes over to move the roof rearward.

If your roof isn't retracting at all, not even unlocking, you might want to check that you're getting current to the lock/unlock motors after the package tray extends.

I have just a rudimentary knowledge of this system. If you have been in contact with Wayne R, you might ask him. If anyone has an answer, he does.