Search:

Type: Posts; User: Ford Only

Page 1 of 5 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    2
    Views
    2,200

    The color is called argent a silver grey color, a...

    The color is called argent a silver grey color, a close match is cast aluminum paint.
  2. Replies
    2
    Views
    1,538

    Mac's may have the early style cam shaft, most...

    Mac's may have the early style cam shaft, most re-builders use the later style cam but then you need the parts off the later engine to hold it in and that includes the timing chain cover.
  3. Replies
    2
    Views
    2,382

    This is on e-bay...

    This is on e-bay...
  4. Replies
    7
    Views
    67,046

    You could use heavy roofing felt (tar paper) and...

    You could use heavy roofing felt (tar paper) and glue it in, with a little effort you could probably get it to slide under the braces to make it look like the original which was sandwiched between...
  5. Replies
    7
    Views
    67,046

    That insulation was painted when the car was...

    That insulation was painted when the car was built but the paint would soak into the tar based insulation and it would look as though it was not painted, rather than trying to replace the insulation...
  6. Replies
    6
    Views
    43,158

    Adjust switch so deck lid lifts higher/read my...

    Adjust switch so deck lid lifts higher/read my reply to your other post.
  7. Replies
    5
    Views
    54,409

    I'm not sure why your deck lid didn't lift high...

    I'm not sure why your deck lid didn't lift high enough for the roof to go into the trunk. The roof should not have even lifted off the body unless the trunk lid was open all the way and the switch...
  8. Replies
    1
    Views
    52,835

    You should buy the technical manual offered for...

    You should buy the technical manual offered for sale from the IFRC you will find all the information you are looking for and more. 1-315-877-6553
  9. Thread: Fuel pump

    by Ford Only
    Replies
    4
    Views
    129,372

    My suggestion would be to go with a electric fuel...

    My suggestion would be to go with a electric fuel pump and electric wipers, The electric wiper motor from a 1957 Chevy will fit or you can buy the electric wiper kits form most any of the Ford...
  10. Replies
    1
    Views
    1,548

    Order from a Ford vendor....

    Order from a Ford vendor. http://www.jerrysclassiccars.com/
    The lines are 3/16" and the fittings are 3/8" IFM.
  11. Keeping things original doesn't always make good...

    Keeping things original doesn't always make good since, I have 15 old Fords and I keep them mostly original but for safety and reliability I do change things.
    I always convert the ignition system...
  12. Thant is what it supposed to do if there is too...

    Thant is what it supposed to do if there is too much coolant in the radiator. You should add a coolant recovery system to keep it from overflowing onto the ground, it just takes a recovery style cap...
  13. Replies
    3
    Views
    41,644

    You need to take the pin out and remove the...

    You need to take the pin out and remove the lever, there is probably a deep grove wore in it where it rubs on the detent plate.
    If you have or know some one with MIG welder they/you can fill in the...
  14. Replies
    3
    Views
    50,139

    I think everything your asking has been answered...

    I think everything your asking has been answered somewhere in this forum before but anyway your numbers sound right for a early 352 engine, I don't think you can tell for sure if you have the 352 or...
  15. I doubt if you would have a problem with the...

    I doubt if you would have a problem with the modern grease it is probably better than it was years ago, I use Tractor Supply brand 80w90 in my cars and I never have had any problems.
  16. I think that a v belt would be adjusted in inch...

    I think that a v belt would be adjusted in inch pounds not foot pounds but I don't think that it would be necessary to adjust with a gauge, if you can deflect the belt more than 1/2" it probably...
  17. Thread: help

    by Ford Only
    Replies
    1
    Views
    2,608

    Try Jerry's he should have what you need....

    Try Jerry's he should have what you need.
    http://jerrysclassiccars.com/
  18. Replies
    6
    Views
    6,169

    I think that the engines all set in the same...

    I think that the engines all set in the same distance because if you look at the spacing from the firewall there the same, I believe more space was added on the front of the engine when they came out...
  19. Replies
    7
    Views
    49,681

    You shouldn't be getting much if any oil out of...

    You shouldn't be getting much if any oil out of the breather, if you are getting blow by there should be almost a equal amount of it coming out of the oil fill breather also but of course no oil out...
  20. Replies
    4
    Views
    63,880

    This is a common problem & even though your...

    This is a common problem & even though your matting surfaces look good they are probably not matching up perfectly.
    I have had this problem in the past on some of my cars and if you don't want a...
Results 1 to 20 of 100
Page 1 of 5 1 2 3 4