Search:

Have you tried adjusting the brake shoe's?

Hi Zuber, I allready have one painted in Colonial White, and decaled correctly if you are interested. Or I can paint your's, I have the equipment and paint. email me at: greghumble@hotmail.com and...

Hi Paul, just thought I would comment on your last post. I to have cut the seal from the inside, and found this to be the easiest way to remove the glass. I figure a new seal is only 80 to a 100...

Kent, if you are going to do these your self, I hope you have a lot of patience! You or some one else doesn't matter, it's going to be painstaking! I sat and taped off each black rectangle. I...

None of these fit very well at all, These pot metal parts were only ment to resemble the shape of the quarter, not match it. Since it is pot metal, you can shape it a little with a body file or a...

Are you talking about the chrome bezel or the taillight door that mounts to the body?

Gregg, a very good question! To often I see these paint divider strips put on upside down. The longer part you describe should be up. In other words, hold the molding up to the rear of the car,...

You could use duct tape around the shoulder on the top jack, just enough to take up the slop, then slide the dust cover over the shoulder, hiding the tape, and secure it with the hog ring.

wah2oo, I don't know if I can shed any light on the subject but here goes. The round piece you are describing is a round pressed fiber material with a hole in the center, I call them "donuts". They...

Robert, you might want to post this qestion to our judging chairman for an ok or not ok. Good luck!

Your rear axle housing would have been gloss black, the 3rd member was red oxide primered, the frame was gloss black. The underside of the body was painted with what was called barrel paint. It's...

Hi Guy's, John and I have been talking about this recently. The pump you both are refering to, according to the manual is the Lehigh pump. I know it was used on Fords and Thunderbirds through 61',...

Lynn, That pump you are looking for, was also used on Thunderbird through 61' any way. I'm sure the pullies would have been the same.

Bob, some of these clips can be found on Ebay from time to time, or try to pull up aaveco's web site, or pull up Restoration specialties web site and order there catalogue, if they don't have it, you...

The cardboard cover does not have to be removed, you lift the burtex flap that is stiched to the cardboard cover to gain access to the jack. I have a 58 jack witch is very simmiler to the 59, if you...