Forum: Top

I have a 1958 that I am restoring. When checking the motors, I noted that there is a junction block (?) connection to the top motor. The wires...

When I go through the erect cycle and the top drops down into the screw holes, the right front screw is about 1/4" too high. the screws are aligned,...

I looking for someone in the Southwestern Ontario Canada region that works on retraceable tops. Currently restoring a 1959 and we are having many...

I have a 1958 and when I retract the top it seems to land very hard into the trunk. The car rocks and it feels like it is landing too hard. Is...

I am new to the forum. I have been having work done on my 57 Skyliner. Now when the top is going up the lock down screws are rotating in the wrong...

This is a new 59 for me. I bought with an untested top so am working blind here on it's history. I attempted to fully retract today and at first the...

My late father-in-law's '58 is slowly coming back to life. Both of my in-laws are hoarders and the Skyliner was literally buried in their garage in...

Hi, I'm new to the forum and club. I just purchased a '59 Skyliner and am looking for the top operating toggle switch that mounts under the dash....

We put the deck lid up. It would operate properly. We rewired the entire top. When we went to put the deck lid down, it would not close all the...

I have all the top seals to replace. I'm considering removing the roof - so that I can turn it over and clean out the channels, fix rust spots, etc....

If some of you are like me when the top gets an attitude I'm lost. Lucky for me I found Mike Mathes not only is he an all around nice guy he also...

I have a 1957 retractable that I just purchased. Everything thing on the top seems to work great except for when you retract the top. It sits in the...

I have a 59, the top has been working fine other than occasionally the top not lifting after unlocking, after a couple tries it works. My current...

The top on my 57 won't unlock using the actuator switch. The deck lid unlocks and opens and the tray erects, then nothing happens. I adjusted the...

I had reset the top and the locks ratchet in the erect operation and unlock in the retract cycle. When lowering the top into the trunk the pins...

After my top screws down, a clicking noise in the top continues while the trunk lid closes. Then, frequently the trunk lid will stop after it starts...

I have a trunk lid and a motorized panel with mounting brackets and trim. No rust or dents, copper colored.It has been sitting in a garage for many...

I have a 57 and when I convert to convertible every thing works fine but when I switch back to hard top the trunk lid does not come down all the way....

Hi guys Thought I might add this link but there are many others I have use this method of testing and it works well for trouble shooting, if you...