Forum: Top

Spent some time and made a tool for the deck screws, but the front one are different. Where do you get a set of these tools? Are there more than two...

One of the benefits of membership in the IFRC and this forum is access to the advice and experience of club members. Included is the IFRC’s...

1958 all stock and in very good condition. Recently the top has begun stopping as I bring the it out of the trunk and place it in the closed...

who rebuilds lift and deck jacks?

A couple of days ago I bought a 1959 Skyliner. I've been looking for several months and think I have a project I can handle (with some helpful advice...

I have heard that the Skyliner had an internal leveling system that made the top inoperable if the car was not level. I've been looking around, and...

When they fail AND have been bypassed, can they be repaired ? Who stocks retractable limit switches and what do they cost?

I'm looking for a shop in Ky to repair my top. the deck lid will not raise it just unscrews but will no raise.

Last fall I posted my top front roof lock motor power issue to this forum. In the one response I received it was noted that since the functioning...

I was so pleased with my roof jack question I thought I would try to get lucky again. I broke my roof jack trying to find out why my top works in...

I have a '58 with a roof locking motor that is seized up. Does anyone have a suggestion of someone to do repairs on the motor?

I have a 59 Skyliner that roof goes up perfectly, however will not go past mid point to rest in trunk. Both jack screws goes completely to close but...

Went to a car show yesterday and as I was about to leave I went to put the top up. Once the decklid went down It would stop about three inches from...

I started a new post on my problem to bring attention to another problem. Today I went to put the top down and it did not work properly. The screws...

Hi - can anyone help me out? After cleaning all the mechanisms, I found that the Passenger side deck lift jack has been damaged at some time in the...

I took off the lift jack for repair, and discovered that one side of the rubber bushing where the screw mechanism fits into the floor mounted bracket...

I have new uncut silver mylar for seat side shields. I need a patter to cut by bill horton

I have new uncut silver mylar for seat side shields. I need a patten to cut by (for 1959 retractable) bill horton 220 idylwood athens,ga30605

Needed: I need 2 bolts for the rear roof links. They bolt the roof link to the pivot bracket part number B7A 5153770-A. If you have a couple give...