Forum: Engine

Hello, I have a cracked exhaust manifold on the passenger side (EDC 9430) of my 58 skyliner with a 352 motor. I would like to get a "cheap"...

Gasket/seal in cover at hold down post wingnut. There's a tiny 1/16" factory hole in bottom of said recessed well. Mine has a solid rubber seal that...

From what I can find the 352 oil breather cap should be black and have “oil” stamped twice on the top. Does it also have the ford logo stamped into...

Has anyone done this to their car? I have a 59 with a 352. I recently installed a new Edelbrock AVS carb. This carb had a vacuum port in the back...

Rebuilding the original 1959 4 barrel ford / autolite 4100 carb. The lid gasket has an extra hole by the center air cleaner stud. This appears to...

Anyone know where I can get factory correct battery cables for a '59 with a 352? Are the Thunderbird cables the same as a Skyliner? I see that...

We bought the car when I was about 3 years old I grew up working on it. Later in life Dad had it fully restored he was a member of the club for...

If you are looking for old Ford parts, I sure would not deal with Randy Ankle, that lives in Mesa, at 848 West Kilarea Ave., Here is what happened to...

Can someone help with the diameter and offset of the power steering pump pulley (the one on the pump itself) for a 1959 with A/C? I know it is...

I want to clean out my rocker arm shafts but they have a plug in each end that must be removed to do the job. The removal will result in their...