Forum: Engine

Can someone help with the diameter and offset of the power steering pump pulley (the one on the pump itself) for a 1959 with A/C? I know it is...

I have A 58 with A 352 and I am looking for the Engine Crankshaft and Water Pump pulleys as well as the mounting bracket and Condenser for the Air...

I am working on a "frame-off restoration of a 59, and just had the engine rebuilt. Can anyone tell me what the correct color is for the block, air...

When I park my car after driving coolant runs out of the overflow tube. I drained the system, refilled with Prestone radiator flush, ran it for 60...

Just pulled the engine in my 59 Skyliner, it is a 352 and was told that it is the original engine. After removing the transmission, I found the back...

I seem to be getting excessive oil out of the breather tube. When I removed it and looked at the hole in the back of the intake , it did not seem to...

Gasket/seal in cover at hold down post wingnut. There's a tiny 1/16" factory hole in bottom of said recessed well. Mine has a solid rubber seal that...

Hello! I am new to the forum after "coming into" a 58 352CID skyliner! it is in pieces right now and am focused on getting it started/running...

Hello, I have a cracked exhaust manifold on the passenger side (EDC 9430) of my 58 skyliner with a 352 motor. I would like to get a "cheap"...

I need a two or three sheve waterpump pulley for a '58/'59 352 engine. The water pump is the long shaft type. Pulley is approximately 3 1/2" deep. ...

I have a fresh 292 all set up and dialed in. I'm getting a lot of oil dripping out of my crank case breather tube. Oil is fresh, good, filled to the...

Just wrapping up the final details on a full restoration. I'm having a difficult time getting my low end idle to smooth out. Carb has been...

1957 Skyliner, 292, two speed transmission, completely rebuilt within the last 5 years. Miles on rebuild maybe 800. Currently on a 2400 mile road...

I have a 57 Skyliner with a 2 barrel carb that looks like a factory carburetor. I recently noticed that the choke isn't hooked up. There isn't a...

I have a 58 Skyliner that overheat's..It has a 352 that I have rebuilt. I have had the block boiled, A new 4 core radiator, 2 new water pump's &...

Does anyone know where to get a 57 312 engine?