Forum: Engine

Hi all, I have a 1959, 332 with a 2 bbl. I'm still trying to sort out what is right, OK or plain bad with the car! Too many people have had...

Does anyone have a current number for the correct muflers for a 57 retrac? It is correct to assume the number is the same for all 57 Fairlane models?...

What type of coolant should I be using in my Skyliner. Since I live in Hawaii, there is no concern about cold weather.

I have a '59 352, water temp. and everything works great. When I get home and turn off car water leaks from the small hole on the bottom of water...

How involved is putting in a starter on a 57 312??

Hi, I see there are several questions already posted about freeze/core plugs on the big block (332cid) FE motors. I couldn't find the specific info I...

Can cylinder head with a casting number of 5752113 be a replacement for a cylinder head casting number ECZ-G on a 1957 312?

When turning on the ignition my oil light comes on but not the generator light. I checked the bulb and it is OK. The generator is also working OK. ...

Hi, I am new to the forum, I recently acquired a running 1958 Skyliner project, it had been sitting for almost 30 years. I have been looking for one...

My 59 With 332 engine was missing the temperature sensor when I got it I have ordered a new part, but I am not sure where to mount it. There is a...

Where is the best place to get a fuel pump for a 59 with a 332 engine.

I am due to service my 59 352 retractable.Do you guys have a preference for a particular brand of spark plug.I have some Champion RF11YC.But am more...

Hi, I am asking this for a neighbor of mine as I have done a few times in the past. He has a 59 Retractable and is having a problem where there is...

the center port gets so hot it burns the paint off --it reachs 275 degrees is that safe--I wired the buterfly open on the exhaust that help a little...

I am working on a "frame-off restoration of a 59, and just had the engine rebuilt. Can anyone tell me what the correct color is for the block, air...

I want to replace my voltage regulator but the are sold as 30amps 35amps and 40amps. Does anyone know what voltage the original generator output was.

Where is the needle supposed to be on a 59 temperature gauge at full normal operating temperature? Should it be dead center or around 3/4 towards...