Forum: Engine

I have a 1958 with a 332 engine. It is my understanding the block was painted a one year only light blue teal color. The block is now Ford dark blue....

I want to replace my voltage regulator but the are sold as 30amps 35amps and 40amps. Does anyone know what voltage the original generator output was.

When turning on the ignition my oil light comes on but not the generator light. I checked the bulb and it is OK. The generator is also working OK. ...

I recently removed a 332 from a 59 parts car. Although it is supposed to be low miles, i would rebuild it just to be safe. Does anyone want/need it....

Does anyone have a current number for the correct muflers for a 57 retrac? It is correct to assume the number is the same for all 57 Fairlane models?...

Can cylinder head with a casting number of 5752113 be a replacement for a cylinder head casting number ECZ-G on a 1957 312?

In my '57 Skyliner, 312, the RH rear, just above the starter, freeze/core plug is leaking. Can this be replaced with the engine in the car? Should...

I have a '59 352, water temp. and everything works great. When I get home and turn off car water leaks from the small hole on the bottom of water...

Greetings all, I know "kaput" is not a technical term, but yesterday showing a family gathering how cool the retractable on the 58 is (and...

Does anyone know where to get a 57 312 engine?

The 4 bbl carb that was on my 57 312 has no tag and I am trying to ID it. Can anyone please tell me what the correct 4 bbl carb is and how to ID...

I have a 58 Skyliner that overheat's..It has a 352 that I have rebuilt. I have had the block boiled, A new 4 core radiator, 2 new water pump's &...

I have a 57 Skyliner with a 2 barrel carb that looks like a factory carburetor. I recently noticed that the choke isn't hooked up. There isn't a...

I have a fresh 292 all set up and dialed in. I'm getting a lot of oil dripping out of my crank case breather tube. Oil is fresh, good, filled to the...

Just wrapping up the final details on a full restoration. I'm having a difficult time getting my low end idle to smooth out. Carb has been...

I need a two or three sheve waterpump pulley for a '58/'59 352 engine. The water pump is the long shaft type. Pulley is approximately 3 1/2" deep. ...

Hello! I am new to the forum after "coming into" a 58 352CID skyliner! it is in pieces right now and am focused on getting it started/running...