Forum: Engine

1957 Skyliner, 292, two speed transmission, completely rebuilt within the last 5 years. Miles on rebuild maybe 800. Currently on a 2400 mile road...

We bought the car when I was about 3 years old I grew up working on it. Later in life Dad had it fully restored he was a member of the club for...

Rebuilding the original 1959 4 barrel ford / autolite 4100 carb. The lid gasket has an extra hole by the center air cleaner stud. This appears to...

If you are looking for old Ford parts, I sure would not deal with Randy Ankle, that lives in Mesa, at 848 West Kilarea Ave., Here is what happened to...

Can someone help with the diameter and offset of the power steering pump pulley (the one on the pump itself) for a 1959 with A/C? I know it is...

I got a 90 Amp alternator from: http://www.qualitypowerauto.com/catalog.php?item=547 It looks just like the orig generator and bolts right on. ...

From what I can find the 352 oil breather cap should be black and have “oil” stamped twice on the top. Does it also have the ford logo stamped into...

Hello, I have a cracked exhaust manifold on the passenger side (EDC 9430) of my 58 skyliner with a 352 motor. I would like to get a "cheap"...

Has anyone done this to their car? I have a 59 with a 352. I recently installed a new Edelbrock AVS carb. This carb had a vacuum port in the back...

I want to clean out my rocker arm shafts but they have a plug in each end that must be removed to do the job. The removal will result in their...

Anyone know where I can get factory correct battery cables for a '59 with a 352? Are the Thunderbird cables the same as a Skyliner? I see that...

I am looking for the correct part number for the vacuum fuel pump on a 1959 - 332. The incorrect was installed many years ago by the previous owner....

Hello! I am new to the forum after "coming into" a 58 352CID skyliner! it is in pieces right now and am focused on getting it started/running...

Will 57 skyliner tail pipes work on 58 skyliner

Gasket/seal in cover at hold down post wingnut. There's a tiny 1/16" factory hole in bottom of said recessed well. Mine has a solid rubber seal that...

My 59 had the battery negative connected to a valve cover bolt. I believe this is not the correct spot. Unfortunately parts and workshop book are not...

Does an electric fan have to be wired with a relay. Or can an inline fuse be used/ I would just manually operate the fan switch.

Hi, Has anyone used something other thatn the normal cork gaskets when replacing an exhaust manifold? I remember when I did work on my friends...

How involved is putting in a starter on a 57 312??

I found out the hard way that my gas gauge no longer works. so now I am looking for the sending unit as I'm pretty sure that's where the problem is....