+ Post New Thread
Page 1 of 5 1 2 3 ... LastLast
Threads 1 to 20 of 90

Forum: Engine

Forum for engine related discussions.

  1. Y Block Rocker Arm Shaft Plugs

    I want to clean out my rocker arm shafts but they have a plug in each end that must be removed to do the job. The removal will result in their...

    Started by Fnixon, 01-30-2024 04:14 PM
    • Replies: 0
    • Views: 151
    01-30-2024 04:14 PM Go to last post
  2. Difference between a/c compressor mounts

    For a 1959 352 the a/c compressor mount for select-aire and power steering car is the one in grey in the picture, correct? What is the black...

    Started by Lorkowski, 03-01-2023 11:20 AM
    • Replies: 0
    • Views: 2,974
    03-01-2023 11:20 AM Go to last post
  3. 1959 - 332 Fuel Pump

    I am looking for the correct part number for the vacuum fuel pump on a 1959 - 332. The incorrect was installed many years ago by the previous owner....

    Started by Captain_205, 11-01-2021 06:05 PM
    • Replies: 1
    • Views: 1,689
    12-13-2021 03:40 PM Go to last post
  4. 1958 Skyliner power steering reservoir cover

    Gasket/seal in cover at hold down post wingnut. There's a tiny 1/16" factory hole in bottom of said recessed well. Mine has a solid rubber seal that...

    Started by Ray, 09-14-2021 11:19 PM
    • Replies: 3
    • Views: 1,362
    11-09-2021 04:28 PM Go to last post
  5. zero power, everything kaput

    Greetings all, I know "kaput" is not a technical term, but yesterday showing a family gathering how cool the retractable on the 58 is (and...

    Started by Tom, 07-13-2021 07:29 AM
    battery, fuseable link, ignition switch, no power
    • Replies: 3
    • Views: 1,730
    07-22-2021 07:18 PM Go to last post
  6. Correct Battery Cables

    Anyone know where I can get factory correct battery cables for a '59 with a 352? Are the Thunderbird cables the same as a Skyliner? I see that...

    Started by 59 Retract, 06-20-2021 10:34 AM
    • Replies: 2
    • Views: 1,359
    06-20-2021 05:10 PM Go to last post
  7. Buyer Beware !!!

    If you are looking for old Ford parts, I sure would not deal with Randy Ankle, that lives in Mesa, at 848 West Kilarea Ave., Here is what happened to...

    Started by 53coe, 05-14-2021 10:10 AM
    • Replies: 0
    • Views: 1,284
    05-14-2021 10:10 AM Go to last post
  8. Steering

    Thinking about installing a Borgeson 14:1 ratio power steering box in my 59. Has anyone done this to their car? The install seems pretty...

    Started by 1965JNC, 04-14-2021 10:15 PM
    • Replies: 5
    • Views: 2,675
    05-08-2021 03:19 PM Go to last post
  9. Removing the draft tube and converting to a PCV valve

    Has anyone done this to their car? I have a 59 with a 352. I recently installed a new Edelbrock AVS carb. This carb had a vacuum port in the back...

    Started by 1965JNC, 04-13-2021 10:23 PM
    • Replies: 2
    • Views: 1,321
    04-14-2021 10:02 PM Go to last post
  10. Power steering pump pulley dimensions ford 1959 with select aire

    Can someone help with the diameter and offset of the power steering pump pulley (the one on the pump itself) for a 1959 with A/C? I know it is...

    Started by Lorkowski, 04-08-2021 02:31 PM
    • Replies: 0
    • Views: 1,174
    04-08-2021 02:31 PM Go to last post
  11. Need Correct Belt Diagram for 1959 Skyliner 332CI With P/S and AC

    Recently, I bought a '59 Skyliner 332 CI equipped with AC and PS. I noticed the generator only had one belt attached but the pulley has two channels....

    Started by XCentrick, 02-22-2017 10:26 PM
    • Replies: 3
    • Views: 5,985
    03-29-2021 07:43 AM Go to last post
  12. Carburetor lid “air horn” gasket for a 4100

    Rebuilding the original 1959 4 barrel ford / autolite 4100 carb. The lid gasket has an extra hole by the center air cleaner stud. This appears to...

    Started by Lorkowski, 02-04-2021 06:49 PM
    • Replies: 2
    • Views: 1,911
    02-12-2021 05:51 PM Go to last post
  13. Oil breather cap type for 352 (1959)

    From what I can find the 352 oil breather cap should be black and have “oil” stamped twice on the top. Does it also have the ford logo stamped into...

    Started by Lorkowski, 12-15-2020 08:20 PM
    • Replies: 0
    • Views: 1,521
    12-15-2020 08:20 PM Go to last post
  14. Location of battery ground cable on engine?

    My 59 had the battery negative connected to a valve cover bolt. I believe this is not the correct spot. Unfortunately parts and workshop book are not...

    Started by Lorkowski, 11-03-2020 08:49 AM
    • Replies: 1
    • Views: 2,100
    11-03-2020 07:49 PM Go to last post
  15. what exhaust manifolds will work on 352 Interceptor motor?

    Hello, I have a cracked exhaust manifold on the passenger side (EDC 9430) of my 58 skyliner with a 352 motor. I would like to get a "cheap"...

    Started by Remotecontroller, 06-11-2020 04:12 PM
    • Replies: 0
    • Views: 1,662
    06-11-2020 04:12 PM Go to last post
  16. broken threads on front windshield screws

    Hello! I am new to the forum after "coming into" a 58 352CID skyliner! it is in pieces right now and am focused on getting it started/running...

    Started by Remotecontroller, 04-22-2020 12:49 AM
    • Replies: 1
    • Views: 1,726
    05-27-2020 02:25 PM Go to last post
  17. Correct engine color for 59' 352?

    Just pulled the engine in my 59 Skyliner, it is a 352 and was told that it is the original engine. After removing the transmission, I found the back...

    Started by Paul59Skyliner, 09-26-2013 10:05 AM
    2 Pages
    1 2
    • Replies: 11
    • Views: 33,698
    02-01-2020 09:25 PM Go to last post
  18. Crank case breather tube

    I have a fresh 292 all set up and dialed in. I'm getting a lot of oil dripping out of my crank case breather tube. Oil is fresh, good, filled to the...

    Started by Scott Torvinen, 06-23-2015 12:21 PM
    • Replies: 7
    • Views: 49,681
    02-27-2019 10:16 AM Go to last post
  19. Adding Air Conditioning to a 1959 (don't know where this post belongs)

    Received the kit from Terry at Jerry's. Really looks nice. Steve (my buddy worker) has the compressor mount and compressor installed. No big issues....

    Started by Ddave, 08-13-2018 05:07 PM
    • Replies: 0
    • Views: 2,448
    08-13-2018 05:07 PM Go to last post
  20. Fuel pump

    Hi, Can someone tell me what companies made fuel pump with glass bowl for 1959 ford with 352. Also is there a general part number or manufacturer...

    Started by Finster, 11-04-2017 01:40 PM
    • Replies: 4
    • Views: 129,372
    07-05-2018 03:13 PM Go to last post

+ Post New Thread

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts