Forum for engine related discussions.
1957 Skyliner, 292, two speed transmission, completely rebuilt within the last 5 years. Miles on rebuild maybe 800. Currently on a 2400 mile road...
I want to clean out my rocker arm shafts but they have a plug in each end that must be removed to do the job. The removal will result in their...
For a 1959 352 the a/c compressor mount for select-aire and power steering car is the one in grey in the picture, correct? What is the black...
I am looking for the correct part number for the vacuum fuel pump on a 1959 - 332. The incorrect was installed many years ago by the previous owner....
Gasket/seal in cover at hold down post wingnut. There's a tiny 1/16" factory hole in bottom of said recessed well. Mine has a solid rubber seal that...
Greetings all, I know "kaput" is not a technical term, but yesterday showing a family gathering how cool the retractable on the 58 is (and...
Anyone know where I can get factory correct battery cables for a '59 with a 352? Are the Thunderbird cables the same as a Skyliner? I see that...
If you are looking for old Ford parts, I sure would not deal with Randy Ankle, that lives in Mesa, at 848 West Kilarea Ave., Here is what happened to...
Thinking about installing a Borgeson 14:1 ratio power steering box in my 59. Has anyone done this to their car? The install seems pretty...
Has anyone done this to their car? I have a 59 with a 352. I recently installed a new Edelbrock AVS carb. This carb had a vacuum port in the back...
Can someone help with the diameter and offset of the power steering pump pulley (the one on the pump itself) for a 1959 with A/C? I know it is...
Recently, I bought a '59 Skyliner 332 CI equipped with AC and PS. I noticed the generator only had one belt attached but the pulley has two channels....
Rebuilding the original 1959 4 barrel ford / autolite 4100 carb. The lid gasket has an extra hole by the center air cleaner stud. This appears to...
From what I can find the 352 oil breather cap should be black and have “oil” stamped twice on the top. Does it also have the ford logo stamped into...
My 59 had the battery negative connected to a valve cover bolt. I believe this is not the correct spot. Unfortunately parts and workshop book are not...
Hello, I have a cracked exhaust manifold on the passenger side (EDC 9430) of my 58 skyliner with a 352 motor. I would like to get a "cheap"...
Hello! I am new to the forum after "coming into" a 58 352CID skyliner! it is in pieces right now and am focused on getting it started/running...
Just pulled the engine in my 59 Skyliner, it is a 352 and was told that it is the original engine. After removing the transmission, I found the back...
I have a fresh 292 all set up and dialed in. I'm getting a lot of oil dripping out of my crank case breather tube. Oil is fresh, good, filled to the...
Received the kit from Terry at Jerry's. Really looks nice. Steve (my buddy worker) has the compressor mount and compressor installed. No big issues....
Use this control to limit the display of threads to those newer than the specified time frame.
Allows you to choose the data by which the thread list will be sorted.
Order threads in...
Note: when sorting by date, 'descending order' will show the newest results first.
Forum Rules