Forum: Engine

Greetings all, I know "kaput" is not a technical term, but yesterday showing a family gathering how cool the retractable on the 58 is (and...

I want to clean out my rocker arm shafts but they have a plug in each end that must be removed to do the job. The removal will result in their...

Hi, Over the years I have heard many different suggestions as to what type of oil to use in a classic car. I have heard some people say straight 30...

Hello, I have a cracked exhaust manifold on the passenger side (EDC 9430) of my 58 skyliner with a 352 motor. I would like to get a "cheap"...

I need a two or three sheve waterpump pulley for a '58/'59 352 engine. The water pump is the long shaft type. Pulley is approximately 3 1/2" deep. ...

I have a '59 352, water temp. and everything works great. When I get home and turn off car water leaks from the small hole on the bottom of water...

Hi All, I need to replace my Water Pump in 1959 with 352 engine. When ordering they are askign me if I want the "Long Shaft" pump or not? They...

I want to replace my voltage regulator but the are sold as 30amps 35amps and 40amps. Does anyone know what voltage the original generator output was.

Where is the needle supposed to be on a 59 temperature gauge at full normal operating temperature? Should it be dead center or around 3/4 towards...

Thinking about installing a Borgeson 14:1 ratio power steering box in my 59. Has anyone done this to their car? The install seems pretty...

How involved is putting in a starter on a 57 312??

I am due to service my 59 352 retractable.Do you guys have a preference for a particular brand of spark plug.I have some Champion RF11YC.But am more...

In my '57 Skyliner, 312, the RH rear, just above the starter, freeze/core plug is leaking. Can this be replaced with the engine in the car? Should...

I had a friend install a rebuild kit purchased from CONCOURS PARTS.It leaks.What if anything did he miss!The valve has been sitting outside for 10+...

Has anyone done this to their car? I have a 59 with a 352. I recently installed a new Edelbrock AVS carb. This carb had a vacuum port in the back...

Hi, I am looking to replace my radiator in my 1959 with a 352 Engine. I am trying to determine if I should get a 3 row or 4 row radiator and...

Good afternoon guys I have at long last,decided to get a new radiator and oil cooler rebuilt for my 59. I am having a bigger more efficient rad...